Last updated November 17, 2026
This is general guidance, not a substitute for your owner's manual. Always follow the manufacturer's instructions and safety warnings for your exact model, and when something doesn't match what's described here, check your manual before continuing. Because this is baby gear, treat that doubly — if your machine behaves differently than described, stop and check your manual or contact the manufacturer directly rather than guessing.
We may earn a commission from links on this page.
Most of the time, a cloudy or smelly water tank on the Bottle Washer Pro just needs a proper clean, not a replacement. Baby Brezza doesn't sell a standalone replacement tank in the US, so before you go looking for one, it's worth ruling out a clean first.
The Bottle Washer Pro has two separate tanks, both removable by their handles. The Clean Water Tank feeds water into the wash and rinse cycles. The Waste Water Tank collects what's left over once a cycle finishes.
Baby Brezza's manual is specific about the Waste Water Tank: empty it after every Wash/Dry cycle, and let the water cool first, since it comes out hot. Slide the tank out by its handle, lift the lid, pour the water into the sink, then rinse and dry the tank before sliding it back in.
The manual doesn't give a separate routine for the Clean Water Tank beyond keeping it filled, but one rule is safe to apply to both: never put either tank in a dishwasher, microwave, or sterilizer. The manual also warns against solvents or abrasive pads on the machine's plastic parts generally -- it doesn't call out the tanks specifically, but the same caution is worth applying to them too.
The manual's only documented mineral-scale problem is on one specific part, the stainless steel heating plate, which it says to descale every 20 washes and more often with hard water. It doesn't say anything about the tanks themselves scaling or discoloring.
If you're on hard or well water, though, a cloudy film on a tank is almost certainly the same mineral buildup, just somewhere the manual doesn't name. A rinse with warm soapy water and a full air-dry handles this in most cases. There's no Baby Brezza-documented descaling step for the tanks, so don't put descaling tablets or vinegar in one the way you would the sump.
There's no replace-or-clean checklist in Baby Brezza's manual for these tanks, so what follows is general plastic-housewares sense, not something the manual actually says: a crack, a lid or seal that no longer closes flush and starts leaking, warping from repeated heat exposure, or a smell or mold that comes back even after a full wash and dry are the usual signs a container is actually done, not just dirty.
If you're genuinely at that point, know going in that Baby Brezza doesn't list a standalone Clean Water Tank or Waste Water Tank on its US parts page the way it does the HEPA filter or descaling tablets. The official route is contacting Baby Brezza Customer Care directly for a replacement, not buying a generic tank, since it has to seat correctly for the machine's own "tank not in place" sensor to read it.
A search for a replacement tank turns up listings from overseas retailers, not Baby Brezza's own US store. We can't vouch for whether those actually fit or come from Baby Brezza at all. Asking Baby Brezza Customer Care directly, even just to check what's available for your machine, is the safer starting point before buying one from a third party.
If the display shows "Clean Water Tank Not in Place," "Waste Water Tank Not in Place," or a low-water icon, that's the machine telling you a tank isn't seated or isn't full, not a sign anything is broken. Reseating or refilling the tank clears it in the vast majority of cases.
Pip reminds you exactly when your appliances need care.
Join the Pip waitlistPip isn't affiliated with, endorsed by, or sponsored by any appliance manufacturer. Brand and model names are used only to identify which appliance a guide is for, and belong to their respective owners.